FortiSwitch 端口POE供电功率可否指定成某指定值

Hi all,
 
话说,支持POE供电接口的FortiSwitch支持指定功率为特定值么?
 
像思科可以指定为某指定值
interface GigabitEthernet0/3
 switchport mode access_** power inline consumption 20000**_
 speed 100
 duplex full
 
目前我查文档之找到要不就全局指定
S424DP3X16000301 # config switch global

S424DP3X16000301 (global) # set poe-guard-band
<integer>    Guard band range from 1W to 20W.
 
要不就端口指定为2种模式,但功率都是预先设定好的
The dynamic guard band is set automatically to the expected power of a port before turning on the port. So, when
a PoE device is plugged in, the dynamic guard band is set to the maximum power of the device type based on the
AF or AT mode. The AF mode DGB is 15.4 W, and the AT mode DGB is 36 W. When the FortiSwitch is fully
loaded, the dynamic guard band prevents a new PoE device from turning on.
To avoid this issue, change the port mode using the following commands:
config switch physical-port
edit <port>
set port-mode IEEE802_3AF
end
请问可以实现像思科交换机一样的配置么?
 
已邀请:

要回复问题请先登录注册